![]() Installation was designed with plug and play weather pack connectors giving it a factory operation and seal with the factory connector. ![]() ![]() With the bright LED circuit boards these lights offer a much better illumination over the factory halogen bulbs. Built with full LED circuit boards allowing for a bright Red stop and turn signal function, also integrated in the circuit board is a bright White LED reverse light. These lights have a unique sequential light function or a standard light function giving you a option to customize your look. Once power to the module is removed, the module will reset and resume normal operating functions.NEW Sequential Taillights for the 6th Gen Camaro! These lights provide another alternative to the factory taillights by giving you a completely different look to you Camaro.You may now release the brake pedal, as the running light switch is providing power to the module. Alternatively, to keep the module in show off mode, while still holding the brake pedal, you can turn on the running light switch.Show off mode is now enabled, ***while you are depressing the brake pedal.***.While holding the brake pedal, toggle the running light switch (On – Off).Turn off all lighting, so no power is being transmitted to the tail lights.Other tinting methods can also be used.Most people use the spray-on tint for the exterior of the lenses ( VHT SP888 Red Nite Shades).Carefully re-install the tail lights and tuck the wiring in a save location, where it will not be damaged.Install the desired bulbs into the new pigtails that are provided with the sequential harness.The adapters will be labeled (Passenger side brake pigtail, Passenger side Turn signal pigtail, Drivers side turn signal pigtail). Install the provided 1157 style adapters into the correct factory pigtails.Remove the 8 bulbs that are used for running lights, brake lights, turn signals, and reverse lights (Four 1157 bulbs, Two 194 bulbs, and Two 1156 Bulbs).Replace the original signal light relay with an electronic style (LED Compatible).There are some great videos on YouTube as well. Locate and remove the existing signal light relay (engage the turn signal (Not Hazard Lights) and follow the ticking sound).As it is difficult to determine which LEDs are compatible, I have designed my own compatible LEDs. (Please note that some LEDs are not compatible with this system. The factory signal light flasher will need to be upgraded to an electronic signal light flasher, to accommodate the electronics in the module (I do sell an adjustable, electronic signal light flasher.Brake lights sequence one time and then remain illuminated, until the brake pedal is released.Electronic Signal Light Flasher (x1) (*Note* The Factory Hazard Light Flasher is already Electronic).Some people have spliced into the reverse light wires and install aftermarket LED lights below the license plate. This system requires you to relocate the reverse lights using your own creative method.The 4 bulbs in the sequence include the (Corner marker light, Brake light, Turn signal, Reverse Light) Please note that this is the “4-Bulb” version and will function exactly the same as in the video.
0 Comments
Leave a Reply. |